Hydra-Tech S6150 User Manual
6” hydraulic submersible, Features, Model s6150
MODEL S6150
6” (150 mm) Discharge
6” HYDRAULIC SUBMERSIBLE
HIGH PERFORMANCE,
SOLIDS HANDLING PUMP
The S6150 is a High Performance
Solids Handling Pump for use on jobs
where higher heads or long discharge
runs are encountered such as Lift
Stations or Ship Offloading.
FEATURES
B0109
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website
:
WEIGHT:..................................................... 650 lbs. (294 kg)
HEIGHT:.............................................................. 38" (79 cm)
WIDTH (@ widest point):.................................... 26" (66 cm)
DISCHARGE:....................................... 6", 125# ASA Flange
INLET:................................................... 6", 125# ASA Flange
SOLIDS HANDLING:.......................................... 3" (75 mm)
HOSE PORTS:......1-1/4" Code 61 Flange or 1-1/2" NPT (F)
PUMP BODY:...................................................... Ductile Iron
IMPELLER:.......................................................... Ductile Iron
WEAR RING........................................................ Ductile Iron
SHAFT:.............................................17-4 PH Stainless Steel
SHAFT SEAL:............................................... Silicon Carbide
ELASTOMERS:................................................ Buna N (Std)
HYDRAULIC OIL:................ 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:................................. Max 90 GPM (340 LPM)
OPERATING PRESSURE:............. Max 2500 PSI (170 Bar)
POWER SOURCE:....... Any Open Center Hydraulic System
SPECIFICATIONS
Specifications are subject to change without notice
•
Balanced High Efficiency Two Vane
Closed Channel Impeller
•
Will pass 3" (75 mm) semi-solids
•
Variable Speed hydraulic drive provides
a wide range of performance
•
Oil Lubricated Seals (can run dry)
•
High Efficiency Balanced Vane
hydraulic motor
•
Can be bolted directly into a pipeline or
used as a booster pump
•
Safe Hydraulic Drive can be used where
electric power is hazardous or
impractical
•
Operates with our HT100 to HT200
power units or other hydraulic power
sources capable of flows of 50 - 90 GPM