Hydrotech 2510 Valve nextSand Turbidity & Sediment Filter Operation Manual - Manual (Page 2)

Typical Installations
NOTE: A neutralizing filter is the first unit installed in a water system after the outdoor raw water lines (*) when pH correction
is required.
1
• Maximum Water Temperature = 110°F (43°C)
• Maximum Operating Pressure = 100 PSIG (689 kPa)
• Pipe Size = 3/4”
• Voltage = 110V Standard
• At the stated service flow rates, the pressure drop through these devices will
not exceed 15 psig.
• Peak flow rates intended for intermittent use only (10 minutes or less) and
are for residential applications only. Do not use peak flow rate for commercial
applications or for a continuous rate when treated water supplies are
geothermal heat pump, swimming pool, etc.
• For satisfactory operation, the pumping rate of the well system must equal or
exceed indicated backwash flow rate.
• The manufacturer reserves the right to make product improvements which may
deviate from the specifications and descriptions stated herein, without obligation
to change previously manufactured products or to note the change.
Soft Water
Raw Filtered
Water
Softener Taste & Odour Filter Turbidity Filter
Raw Water
Outdoors
Raw Well
Water
Pressure
Tank
Chlorinator
Flow Meter
Check Valve
Drain Drain Drain Retention
Tank
Model #
Flow Rates USGPM
(for ultrafine particle removal)
Flow Rates for Typical Application
USGPM
Installation
Space
Fiberglass
Tank Size
Inches
Shipping
Weight
Lbs Service Peak Backwash Service Peak Backwash
2510CC-847NEXTSF-75 4.0 5.0 5 5.6 7.0 5 10 x 10 x 57 8 X 47 95
2510CC-948NEXTSF-100 5.0 7.0 7 7.1 8.8 7 11 x 11 x 58 9 X 48 145
2510CC-1054NEXTSF-150 7.0 8.0 8 8.7 10.9 8 12 x 12 x 64 10 X 54 213
2510CC-1252NEXTSF-200 10.0 12.0 12 12.6 15.7 12 14 x 14 x 62 12 X 52 265