Hydrotech 9100 SXT Valve Meter Initiated Water Softener - Manual (Page 7)

6
User Programming Mode Options
Abbreviation Parameter Description
DO Day Override The timer’s day override setting
THIS IS AN OPTION ONLY. PLEASE DO NOT ADJUST
BEFORE CONSULTING AN AUTHORIZED DEALER.
H Feed Water Hardness The hardness of the inlet water - used to calculate system
capacity for metered systems
RC Reserve Capacity The fixed reserve capacity
CD Current Day The current day of week
NOTES:
Some items may not be shown depending on timer configuration.
The timer will discard any changes and exit User Mode if any button is not pressed for sixty seconds.
User Programming Mode Steps
1.Press the Up and Down buttons for five seconds while in
service, and the time of day is NOT set to 12:01 PM.
2.Use this display to adjust the Day Override. This option
setting is identified by “DO” in the upper left hand corner
of the screen.
THIS IS AN OPTION ONLY. PLEASE DO NOT ADJUST
BEFORE CONSULTING AN AUTHORIZED DEALER.
3.Press the Extra Cycle button. Use this display to adjust
the Feed Water Hardness. This option setting is
identified by “FH” in the upper left hand corner of the
screen.
4.Press the Extra Cycle button. Use this display to adjust the Fixed Reserve Capacity. This option setting is identified
by “RC” in the upper left-hand corner of the screen.
75 gallons X # of people in the house = RC
5.Press the Extra Cycle button to end User Programming Mode.
# of People RC
1 75
2 150
3 225