Hydrotech C, C PLUS, A PLUS, E, E-DC and E PLUS Series PULSAtron User Manual
Page 11
11
5.0 START UP AND OPERATION
5.1 POWER
All metering pumps are available in 115 and 230 volts at 50/60 Hertz, single phase.
In addition, certain models are available in 12 volt DC. Prior to start-up always
check to insure that the pump voltage/frequency/phase matches that of the power
supply.
If pump is fitted with a PVC pump head (7
th
position of model
number is “V” or "W". Note: PVC is gray, not black), uniformly
hand tighten the four head screws before use, 18-22 in. lbs.
(3.2 -3.9 kg/cm). Periodically tighten after installation.
5.2 PRIMING
When working on or around a chemical metering pump instal-
lation, protective clothing and gloves and safety glasses should
be worn at all times.
All pumps are tested with water. If the chemical to be pumped
reacts when mixed with water (e.g. sulfuric acid, polymer) the
pump head should be removed and dried thoroughly along with
the diaphragm and valve seats.
FIGURE 8