CAME FerniE-P Kit - Manual (Page 29)

7.3 - ZA4 Control Panel Description
Description of Control Panel:
Micro-processor controlled electrical cabinet powered by 230V (a/c) at
50-60Hz, single phase. Designed for control of CAME (ATI/FERNI/FROG), for
hinged gates, hinged industrial doors. Designed and built entirely by CAME to
meet UNI8612 safety standards at an IP 54 level of protection. Housing made of
ABS is equipped with vents to provide internal air circulation. Guaranteed for 3
years, unless tampered with. This control panel is powered 230V a.c across
terminals L1 and L2, and is protected by a 5A fuse on the main power line.
Control systems are powered by low voltage and protected by a 2A fuse. The
accessories total wattage (24V) must not exceed 20W.
The Control Panel and Motors should be suitably Earthed
Safety:
SAFETY BEAMS CAN BE CONNECTED TO OBTAIN:
Re-Opening: During closing (2-C1), if the beam is broken while the gate is
closing, they will reverse the direction of movement until the gate is
completely open and will stay open until the obstacle is removed.
Total Stop: (1-2) Creates immediate stop of gate movement without automatic
closing: (a pushbutton or radio remote control must be
actuated to resume movement).
N.B IF A NORMALLY CLOSED SAFETY CIRCUIT
(2-C1, 1-2) IS OPENED, THE L.E.D WILL
FLASH TO INDICATE THE FACT THAT THE BEAM IS
BROKEN.
28
Accessories that can be Connected to this Unit:
“Gate in Motion” Lamp: The lamp that lights the manoeuvering zone: it remains
lit from the the moment the gate begins to open until
they are completely closed (including the time required
for the automatic closure). When automatic closure is
not enabled, the lamp remains lit only during
movement (E-E3).