CAME Gard 8 24v D.C - Manual (Page 12)

12
T
h
e d
at
a a
n
d i
n
fo
rm
at
io
n p
rovi
d
ed
i
n
t
h
is
m
an
u
al
a
re to b
e c
o
n
si
d
er
ed
s
u
sc
ep
ti
b
le to c
h
an
g
e a
t a
n
y t
im
e w
it
h
o
u
t w
ar
n
in
g
, by CAM
E c
an
ce
ll
i a
u
to
m
at
ic
i S
.p
.A
.
ENGLISH
^—
^—
^—
^—
- The procedure is similar for the bar’s opening position. Adjust the closure
damper screw until a position parallel to the road surface is reached.
Warning! The bar’s stop position is preceded by the slowing phase by means
of a tab and spring system that activates the slowing-down microswitch prior
to the bar’s total stop.
5.8 End stop adjustment
Power up the electric board, carry out a series of steps to make sure of the bar’s correct opening and closing positions, and
then, if necessary, proceed to the adjustment of the dampers.
Warning! For greater safety and better unit performance, the bar’s opening and closing operations should be carried out with
the inspection hatch closed!
- Execute the closing operation, adjust the open
bar’s position by turning the free damper clockwise
(to increase the bar’s run) or counter-clockwise (to
decrease the run). Adjustment of the position with a
~89° aperture from the closed position is recommen-
ded.