Clear-Com KB-701 - Manual (Page 9)

K B - 7 0 1 S P E A K E R S T A T I O N
1 - 3
2. Call Button: Pressing the call button sends a call signal on the intercom
line and causes all the call lights on other stations on the intercom channel
to light.
The call button lights red when a call signal is sent or received on the
intercom line.
3. Speaker: The audio output for the KB-701 device.
4. Volume Control: Turn this control to set the speaker’s required listen
level. This control does not affect the tone alert level or the program input
level.
5. Program Level Control: Adjust the program level control to set the
program audio level heard in the panel speaker.
Note: Forcing the trimpots past their stop points will damage them.
6. Integral Microphone: The microphone for the KB-701 is built into the
front panel.
INTERNAL ADJUSTMENTS AND CONNEC-
TIONS
The controls and connectors inside the KB-701 are shown in the following
figure and described by the following text. The controls can be accessed
without completely removing the panel from its wall box or V-Box enclosure
by removing the top two screws and loosening the bottom two screws a few
turns. The panel can then be leaned out from the wall to make the controls
accessible as shown in the lower view of Figure 1-2.
Figure 1-2: Internal Controls
P3 Must be
installed if
no option
P1 Must be
installed if
no option
1 2 3
10
11
8 7
View from top
of KB-701
Front Panel
12
9