Audison LRX 5.600 - Manual (Page 10)

SETTING PANEL
10
It permits to reach the switches for the amplifier configuration, the resistors to set subsonic filter cut-off
frequency and to insert VCA modules for the subwoofer volume remote control.
AMPLIFIER CONFIGURATION
LRx 5.600 is configured through IN SELECT, Ch. SELECT, MODE and IN SUB/MIXED SUB (F+R) switches,
located under the setting panel.
• IN SELECT (1 IN – 2 IN)
It permits to use OUT preamplified output as additional input for the head unit Rear preamplified
output, if available (2 IN). This configuration also activates Constant Bass function.
If this switch is on 1 IN, you will be able to make a Front+Rear+Sub system by using only the Front input.
• Ch. SELECT (5 Ch. – 3 Ch. mono)
It configures the amplifier output as 3 or 5 channels. If switch is on 5 Ch., you will be able to make a
Front+Rear+Sub system; if it is on 3 Ch. mono, you will be able to have a Front+Sub system.
• MODE
It permits to choose the amplifier functioning configuration between
Front-Rear and Multichannel. If switch is on Front-Rear, Hi-Pass filters for
Front (F2) and Rear (F3) system are activated. If it is on Multich., Hi-Pass
filters for Woofer (F2) and for Woofer/Mid-Tweeter (F4) are activated.
• IN SUB/MIXED SUB (F+R)
It activates IN SUB input to accept the source third preamplified output
for subwoofer (IN SUB).
In case source doesn’t have it, it is possible to drive the subwoofer by
taking the necessary signal from IN Front and IN Rear inputs (MIXED SUB
F+R).
2 - Once operations have
been carried out, please
close the setting panel.
1 - Remove the setting panel in the
amplifier bottom in order to carry out
operations.
ACCESSORIES
15
FUNCTIONS Installation:
First fan Second fan
Battery
12 V
+ Ground
Remote
IN
Remote
OUT
Remote
+
POWER
Setting panel