Clear-Com BS850 (Last time buy) - Manual (Page 21)

Base Station Dial Adjustment Setting:
Select Fine or Coarse for the control knob, for mix
level dial adjustments. In the Fine mode, mix
level adjustments made by the control knob occur
in 0.25dB increments. In the Coarse mode, they
occur in 2.25dB increments.
Beltpac Configuration Settings
Beltpac configuration settings are stored in the base station, but do not become effective until they are
uploaded into individual Beltpacs. In a Master/Slave configuration, all Beltpac settings changes must be
made at the Master. Uploading is also done at the Master. Be sure to SYNC bases after making settings
changes at the Master.
Beltpac Transmitter Power:
Select the desired Beltpac and its transmitter
power level (1, 10, 50 or 100mW).
Select the transmit mode and press ENTER.
In the auto mode, transmitter power will be auto-
matically controlled by the base station, changing
between 1 and the specified maximum. In the
fixed mode, the setting you select will not change.
If you select ptt, the Beltpac transmitter will be on
briefly every few seconds to transmit status. If
you select pts, the Beltpac will only transmit
while a user is talking. If you select pte, the
Beltpac will transmit constantly.
If Beltpacs are going to share the same transmit
frequency, select pts. If you select pts, you must
also select Ptt Shared in the Base Receiver
Frequency Setup (See page 14).
Beltpac Transmitter Frequency:
Select the desired Beltpac and the transmitter
frequency for that Beltpac’s operation (P1-12, S1-
12, T1-12 and U1-16. If U1-16 is selected, use
the control knob and the up and down arrow
buttons to select the desired frequency, in 25kHz
increments.
NOTE: Settings for Beltpacs BP1-BP16 are stored
in the base station. Changes to Beltpac settings will
not be effective until they are uploaded to the
Beltpacs. BPCN is the headset that is plugged into
the base station, therefore changes to its settings are
effective immediately.
18