Clear-Com CC-260 (No longer available) User Manual
Intercom headsets, Installation instructions, Specifications
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Intercom Headsets
- CC-95/CC-260
- The CC-95 and CC-260 intercom headsets can be used with Matrix stations and Party Line stations a...
- Note: This is a good practice before plugging or unplugging any headset to a beltpack or station.
- 2. Adjust the boom, but do not force it past the 11 and 1 o’clock stop points.
- 3. Place the ear socks over the earpads for a more comfortable fit, especially during extended pe...
- 4. If necessary, adjust the station or beltpack sidetone and/or listen level.
- 5. After putting on the headset, position the microphone using the flexible section of the boom. ...
- Note: The use of headset extension cables is not recommended with Party Line products because of ...
- Transducer type Dynamic moving coil
- Nominal impedance 420 ohm single muff; 210 ohm, double muff
- Frequency response 70 to 18 kHz
- Maximum continuous SPL CC-95: 127 dB at 1 kHz at 250mW;
- CC-260: 125 dB at 1 kHz at 250mW
- External noise isolation > 20 dB avg. at 300 to 5000 Hz
- Sensitivity Sound-pressure level at 1mW — CC-95: 101 dB at 1 kHz
- CC-260: 103 dB at 1 kHz
- Transducer type Dynamic moving coil
- Polar pattern Cardioid; noise rejecting
- Windscreen External pop filter
- Nominal impedance 200 ohm balanced
- Frequency response 70 to 18 kHz
- Front-to-back ratios > 15 dB
- Headset material ABS, Duracon®, and alloy
- Finish Grey and black matte non-reflective
- Electrical isolation Earphone to microphone < -116 dB at 1 kHz
- Headset cable Specially shielded and isolated straight cord
- Length 5 ft. 6 in. (1.75 meter)
- Termination 4-pin XLR female
- Termination options 4-pin XLR male (monaural), 5- or 6-pin male or female
- (binaural), or special connectors upon request
- Boom rotation 300o
- Weight (without cord) Single muff, 10 oz. (283g); double muff, 14.1 oz. (399g)
- Furnished accessories One pair ES-1 washable ear socks (double muff); 1 ES-1
- ear sock (single muff)
- Clear-Com Limited Warranty
- This Clear-Com product is warranted to be free from defects in materials and workmanship for a pe...
- This warranty is the sole and exclusive express warranty given with respect to Clear-Com products...
- Any and all implied warranties, including the implied warranty of merchantability are limited to ...
- Do not return any equipment to the factory without first obtaining a Return Authorization Number.
- All equipment returned for repair must be accompanied by documentation stating the return address...
- Send equipment to be repaired to: Customer Service Department, Clear-Com Intercom Systems, 4065 H...
- If in warranty, no charge will be made for the repairs. Equipment being returned for warranty rep...
- Equipment that is not under warranty must be sent prepaid to Clear-Com. If requested, an estimate...
- Note: All specifications subject to change without notice. PN 810261