Hach-Lange LICO 690 User Manual - Manual (Page 44)

44
Standard programs
5.3.3.1 Automatic/manual saving of single and multi-wavelength measurements
The data log function indicates whether data is to be stored
automatically or manually (in the latter case, the user must decide
which data is to be saved).
1. Press Data Log Setup in the "Instrument Setup" menu.
• With the Auto Store: On setting, the instrument
automatically saves all the calculated measured data
"after the measurement" or alternatively "after removing
the cuvette".
• With the Auto Store: Off setting, the instrument saves
no measured data automatically. In measurement mode,
Options > Save can be used to save the currently
displayed measured value.
2. Specify the output format of data to be exported using Send
Data Format. Select xml or csv.
3. Press OK to confirm the entry.
The instrument then returns to "Instrument Setup".
Note: When the measured data memory of the instrument has reached
its maximum storage capacity, the oldest data record is automatically
deleted so that the new data can be saved.
5.3.3.2 Recall single and multi-wavelength measurements from the measured data memory
1. In the main menu, press the Recall Data menu option.
2. Press Data Log.
A listing of the stored data is displayed.