Hach-Lange EVITA OXY Basic User Manual - Manual (Page 97)

English 97
Programming of the USC 5000/7000
The configuration of the transmitter EVITA ® OXY is done via the keypad.
It also enables the access to the various functions:
Figure 18 Keypad and layout of the display
Important:
After the setup of the USC the "Language" menu is displayed in English.
Long press the key CHANGE until the desired language is shown in the
display. Then you confirm your selection with key LOCK/UNLOCK
(ENTER).
The USC is then in the operator menu and shows the concentration.
The default setting of the language is established again as follows:
•
Switch off the device whereby you make it without power.
• Press the key BACKWARDS, and with this switch the device on
again.
• Let go of the key BACKWARDS again after 10 seconds.
The language is now set back to English.
Key TOP UP (ESC)
When you hold this key pressed 2 seconds
long, you go from the operator menu to the
setup menu. When you press this key only
briefly, you return to the higher-level menu.
Key FORWARDS
With this key you scroll forward through the
individual menus of the setup menu.
Key BACKWARDS
With this key you scroll backward through
the individual menus.
Key CHANGE
With this key you can change the settings or
the numerical values in the setup menu. In
the operator menu it serves to scroll through
the individual menus.
Key SELECT
With help from this key you select the digits
that you would like to change.
Key LOCK/UNLOCK (ENTER)
With this key you can change the settings
and access the various submenus.
Various
display symbols
Ready for the replacement
Value saved
Access to submenu
Confirm