Hach-Lange LDO101-30 Instruction Sheet - Manual

1
LDO101R89
Instruction Sheet
LDO101-05, LDO101-10, LDO101-15, or LDO101-30 Probe
CAUTION
BEFORE ATTACHING THE PROBE FOR THE FIRST TIME: Set the date and time in the
meter before attaching the probe for the first use. If the meter date and time are
changed after the probe is installed, the probe will retain an incorrect time stamp for the
remainder of its service life, even if the meter time and date are later corrected.
Safety
To ensure that the protection provided by this equipment is not impaired, do not use or install
this equipment in any manner other than that specified in this document.
CAUTION
When deploying the probe at a distance, toss the probe body with a gentle underhand
throw. Swinging the probe by the cable may cause injury to the user, will cause severe
strain on the probe cable, and will shorten service life. Damage incurred in this manner
will not be covered by the product warranty.
Overview
Figure 1 shows the LDO101-05, LDO101-10, LDO101-15, or LDO101-30 Probe, a
luminescent dissolved oxygen (LDO) probe with a bell-and-ring shroud. The probe can
be equipped with a 5-, 10-, 15-, or 30-meter cable. The probe is designed for fast, accurate
measurement of dissolved oxygen concentration in wastewater, drinking water, and
general applications.
Each probe is supplied with color-code clips for easy identification. There are two each of five
colors (black, yellow, light green, light blue, and magenta), one for the probe and one for the
cable connector. Attach a pair of color-code clips to the probe and cable connector.
Replacement sensor caps (including the iButton ® *) are available (Cat. No. 58112-00).
Optional probe-cable depth markers are also available (Cat. No. 58286-10).
This symbol, if noted on the instrument, references the instruction manual for operation and/or safety information.
Electrical equipment marked with this symbol may not be disposed of in European public
disposal systems after 12 August of 2005. In conformity with European local and national
regulations (EU Directive 2002/96/EC), European electrical equipment users must now return old
or end-of life equipment to the Producer for disposal at no charge to the user.
Note: For return for recycling, please contact the equipment producer or supplier for instructions on how to return
end-of-life equipment, producer-supplied electrical accessories, and all auxiliary items for proper disposal.
* iButton is a registered trademark of Maxim Integrated Products, Inc.