Hach-Lange FP 360 sc User Manual - Manual (Page 13)

13
Installation
3.2 Installation options
The sensor may need to be installed with additional optional accessories depending on
the area of application (refer to section
7.3 on page 27 ).
Note: Refer to the documentation supplied with the accessories for detailed installation instructions.
3.2.1 Installation with the chain mount kit
The FP 360 sc sensor is installed with the chain mount kit in open channels, shafts and
tanks.
3.2.2 Installation of chain mount kit for sensors with cleaning unit
3.2.2.1 Install the cleaning unit hose
Note: An air hose is required, to operate the sensor with the optional cleaning unit. An oil-free
compressed air (6 bar) and a solenoid valve or the HOAB compressed air cleaning system is also
required (refer to section
7.3 on page 27 ).
With the HOAB compressed air cleaning system, replace the end of the hose connection
that is connected to the compressed air on the underside of the instrument with the
straight 6 mm fitting (refer to
Figure 2 on page 9 , item 5) supplied with the probe.
Figure 6 FP 360 sc measurement sensor with chain mount kit