Hach-Lange BUHLER 1027 wall mount automatic water sampler (BL series) - Manual (Page 43)

Operation
Page 43 Manual Bühler 1027
1.1.8
**********************
SETUP
**********************
SETUP
Enter general settings like
• Date, time
• Language
• Modem
• System settings
1.1.9
**********************
MEMORY
**********************
MEMORY
Here you can display or delete stored information like:
• Info memory (sampling protocol)
• Bottle memory
• Analogue signal
1.1.10
**********************
SERVICE MENU
**********************
SERVICE MENU
In the service menu the single components and the inputs can be
tested. However, modifications should only be carried out by
specially trained service personnel.
EXAMPLES FOR STANDARD PROGRAMS
2. Programming of a „TIME-PROPORTIONAL“ sampling program
In this sampling mode, a sample is extracted as a function of a programmed time interval.
1.1.4
**********************
PROGRAM NO. 1
TIME
INTERVAL HRS. 0:06
FILLING TIME H 2:00
**********************
Selection of the program number:
After having pressed the ENT key, a program number (1 to 6) can be
entered.
Confirm by pressing the ENT key.
Next menu: press the „DOWN“ arrow key.
1.1.5
**********************
PROGRAM NO. 1
*CHANGE
DELAYED START
START
**********************
PROGRAMMING
- Press the ENT key (cursor is displayed flashing)
- Press the „UP“ arrow key twice
- Confirm with ENT
2.2.1
**********************
PASSWORD
****
**********************
Enter the valid password (factory-set code is 6299).
Remark:
This is only required if a password has been activated in „Setup“->
„System settings“. If not, just press the ENT key and you will get to
the next menu!
If the right password has been entered, you will automatically get to
the next menu.