INSTEON Keypad Dimmer (Dual-Band) (2334-2xx US) Manual - Manual (Page 11)

Page 11 of 24 Rev: 7/25/2013 9:16 AM
- Adjust the responder to the desired scene state (for Keypads you must tap the button at least once to reach
the desired state).
- Press and hold responder’s Set button until it beeps and/or LED flashes
Keypad will double-beep
5) After all responders have been added, Tap Keypad’s Set button
Keypad’s scene button and Set button LEDs will stop blinking
Keypad’s LEDs will return to normal brightness
6) Test scene by tapping the scene button a couple of times
All the responders added above will respond
Remove Multiple Scene Responders
1) Tap the scene controller button on Keypad
2) Press and hold Keypad’s Set button until it beeps
Keypad’s scene button LED will blink and Set button LED will blink green
All illuminated LEDs on Keypad will brighten to 100%
3) Press and hold Keypad’s Set button again until it beeps again
Keypad’s scene button and Set button LEDs will continue blinking red
4) Tap Keypad’s Set button
Keypad’s scene button and Set button LEDs will continue blinking red
5) For each responder you are removing:
- If it’s a Keypad button, tap the button
- Otherwise, press and hold responder’s Set button until it beeps and/or LED flashes.
6) After all responders have been removed, Tap Keypad’s Set button
Keypad’s scene button and Set button LEDs will stop blinking
Keypad’s LEDs will return to normal brightness
7) Test scene by tapping the scene button a couple of times
All the responders added above will respond
Synchronized Scenes
Synchronized scenes are scenes where all members stay synchronized. Common examples include 3-way lighting
circuits and scenes with a single load-bearing device.
Example: 3-Way Circuit (Circuit with 2 Keypads, A and B)
1) Turn both loads on to the desired (and same) scene level
2) Press and hold A’s Set button until it beeps
A’s scene controller button will blink and Set button LED will blink green
3) Press and hold B’s Set button until it double-beeps
B’s scene controller button and Set button LED will flash
A will double-beep and its LEDs will stop blinking
4) Press and hold Switch B’s Set button until it beeps