INSTEON OutletLinc Relay (2473SWH) Quick Start User Manual
Quick start guide, Insteon, Outletlinc™ on/off outlet model: 2473s
2473S Rev. 11/8/2012 6:54 PM / See Owner’s Manual for Warranty Information.
Protected under U.S. and foreign patents (s
© Copyright 2012 INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 866-243-8022
Quick Start Guide
INSTEON
®
OutletLinc™ On/Off Outlet
Model: 2473S
Tools Needed
•
Flathead screwdriver
• Phillips screwdriver
•
Wire cutter/stripper
• Voltage tester
Installing OutletLinc
Installation should only be performed by a qualified electrician or a homeowner who is
familiar and comfortable with electrical circuitry. If you have questions, consult an electrician
or call the INSTEON Support Line at 866-243-8022
1)
At the circuit breaker or fuse panel, disable circuit supplying power to outlet
2)
Remove existing outlet and wallplate
3)
Disconnect wires from existing outlet and ensure you have ½” of bare wire on the ends
4)
Enable power to the outlet, then use voltage meter to identify line, neutral and ground
wires. Once wires are identified, turn off circuit breaker.
5)
Twist OutletLinc ground wire (bare copper) to outlet ground wire with included wire nut
6)
Twist OutletLinc neutral wire (white) to outlet neutral wire with included wire nut
7)
Twist OutletLinc line wire (black) to outlet line wire with included wire nut
8)
After ensuring all wire connectors are firmly attached and that there is no exposed copper (except for ground wire), carefully
place OutletLinc into wall box and replace wallplate
9)
Turn on circuit breaker
10)
Plug lamp, appliance or other device you want to control (load) into OutletLinc top outlet
11)
Test by tapping OutletLinc Set button a few times
Connected light/load will turn on and off
Make OutletLinc a Responder
Control OutletLinc from another INSTEON device:
1)
Put controller into linking mode.* (For most controllers press and hold Set button for 3 seconds or an on/scene button for 10
seconds.)
2)
Turn on load plugged into OutletLinc
3)
Press and hold OutletLinc Set button for 3 seconds
Status LED will flash, then turn on solid
4)
Confirm link by tapping controller’s button on and off
Connected light/load will turn on and off
Owner’s Manual and Tech Support
For the complete Owner’s Manual and the most up-to-date Quick Start Guide visit
Call: INSTEON Support Line at 866-243-8022
*Linking mode will time out after 30 seconds
Set
button
INSTEON controlled
on/off receptacle
Status
LED
Always-on uncontrolled
receptacle