INSTEON OutletLinc Dimmer (Dual-Band) (2472DWH) Quick Start - Manual

Rev. 7/16/2012 12:34 PM / See Owner’s Manual for Warranty Information, Patented
© Copyright 2012, INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
Dimmer Key
(magnet faces plug)
Quick Start Guide
OutletLinc ™ Dimmer - INSTEON ® Remote Control Outlet
Models: 2472D
Installation
Note: Installation should be performed only by a qualified electrician or a
homeowner who is familiar and comfortable with electrical circuitry. If you
have any questions regarding installation, consult an electrician.
1) Turn off circuit breaker
2) Remove trim plate and old outlet
3) Connect OutletLinc's bare copper wire ground wire with wire nut
4) Connect OutletLinc's white wire to neutral wire with wire nut
5) Connect OutletLinc's black wire to line/hot wire with wire nut
Ensure all connections are solid and safe
6) Carefully install OutletLinc into electrical box and replace trim plate
7) Turn circuit breaker back on
OutletLinc's LED will blink red for about 1 minute
8) Slip OutletLinc Dimmer Key over the prongs of your lamp's plug (the
circular magnet protrusion will face the lamp's plug). See photo.
9) Plug lamp (with Dimmer Key) into top outlet on OutletLinc
The lamp will turn on and OutletLinc's LED will turn green
10) If the lamp does not turn on, turn it on manually using lamp's switch
11) Tap Set button on OutletLinc
Lamp will turn off (if on) and on (if off)
LED will be green when lamp is on and red when it is off
Add OutletLinc to a Scene as an INSTEON Responder
1) Plug lamp (with Dimmer Key) into top outlet
LED will turn green (if not, rotate knob/switch on lamp until it
turns green )
2) Press and hold the controller scene button until it beeps*
Controller LED will blink
3) Press and hold Set button on OutletLinc until it double-beeps
OutletLinc's LED will flash once and return to green
4) Confirm that linking was successful by tapping the controller scene
button on and off
The lamp plugged into the OutletLinc will turn on and off
Owner’s Manual and Tech Support
Owner’s Manual and current Quick Start Guide:
http://www.insteon.com/support
Call: INSTEON Support Line at 800-762-7845
*Most products
Status
LED
Controlled
receptacle
Set button
Always On
receptacle
Wallplate
(sold separately)
This device complies with FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes: (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement.