INSTEON In-LineLinc Relay (Dual-Band) (2475SDB) Quick Start - Manual

Rev. 7/16/2012 12:34 PM / See Owner’s Manual for Warranty Information, Patented
© Copyright 2012, INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
*If the controller does not have a beeper, wait until its LED begins blinking
**Most products
Quick Start Guide
In-LineLinc ™ Relay (Dual-Band)
Models: 2475SDB
Installation
Note: Installation should be performed only by a qualified electrician or a
homeowner who is familiar and comfortable with electrical circuitry. If you
have any questions regarding installation, consult an electrician or call the
INSTEON Support Line at 800-762-7845.
1) Be sure to write down the INSTEON I.D. and location of the fixture
you'll be controlling (e.g., 01.F7.G5, Upstairs Bathroom Fan)
2) Turn off circuit breaker supplying power to the fixture
3) Disconnect the wires from the fixture you will be controlling and
ensure that you have ½” of bare wire on the ends
4) See Figure 1 to identify and connect the line, load, neutral and ground
wires on In-LineLinc. Be sure you have correctly identified the wires in
the junction box before connecting them.
5) After you have connected all the wires, ensure that the wire
connectors are firmly attached and that there is no exposed copper
except for the ground wire
6) Prior to reinstalling the fixture, turn on circuit breaker supplying power
to the fixture
7) Use the on/off buttons to test that the module is working and
controlling the load
8) Add In-LineLinc to a scene as a responder:
Use the On and Off button on In-LineLinc to set the load to the
state you wish to activate from the controller (turn it on if you wish
it to be on when the controller activates the scene, etc.). Press
and hold the scene controller button until it beeps. *
Controller LED will blink
Press and hold In-LineLinc's Set button until it double-beeps
In-LineLinc status LED will flash once and then turn on
steady. Controller will double-beep** and its LED will stop
blinking
Confirm that scene addition was successful by tapping On then
Off on the controller's scene button
The load connected to the In-LineLinc will respond
appropriately
9) Gently place In-LineLinc into the junction box, making sure that
nothing could accidentally press any of the buttons on its face
10) Reinstall the fixture
Status
LED On button
Off button Set button
Figure 1
Owner’s Manual and Tech Support
Owner’s Manual and current Quick Start Guide: http://www.insteon.com/support
Call: INSTEON Support Line at 800-762-7845
This device complies with FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes: (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement.