INSTEON Micro Open/Close - 2444-222 (US), 2444-422 (EU), 2444-522 (AUS/NZ) Manual - Manual (Page 9)

Page 9 of 21 2444-222/2444-422/2444-522 - Rev: 2/24/2014 9:10 AM
Reverse Motor Direction
For some applications, such as a projector screen, you want the connected motor to lower or close your connected
screen or blinds when you press the up button or send an on command. Or you may have accidentally wired Micro
module into the motor wrong. However, you don’t have to rewire Micro module to fix it. Follow these steps to reverse
the motor direction in response to commands (i.e., an on command will close/lower while an off command will
open/raise).
1) Press and hold Set button until it beeps
LED will start blinking green
2) Press and hold Set button until it beeps again
LED will start blinking red
3) Press and hold Set button until it beeps a third time
LED will start blinking green
4) Press and hold Set button until it beeps a fourth time
LED will start blinking red
5) Slowly tap Set button three times
LED will continue blinking red
6) Press and hold Set button until it double-beeps
7) Test by tapping connected switch up and down
Motor will now operate in the reverse direction
Local Control Operation
Micro module’s switch operation mode affects how it responds to commands from the switch. This is why it’s
important to program Micro module for the specific type of switch you are using. Micro module’s up/down buttons
function exactly like the top and bottom of your wall switch.
Latching Switch (Default)
Note that this table refers to the latching switch operation if 3-way toggle mode is disabled (it is enabled by default)
and the motor direction has not been reversed.
Single Momentary Switch
Connected load/responders
Latching switch Tap LED
Top Up/On Green
Bottom Down/Off Red
Connected load/responders
Single momentary switch Tap Press and hold Double-tap LED
Switch
Up/Down
On/Off
(ramped)
Up/Down
Brighten/Dim
until release or full-on/off
(dimmable responders only)
Up/Down
On/Off
(instant)
Green/
Red