INSTEON Thermostat Adapter (2441V) Manual - Manual (Page 8)

Thermostat Adapter Owner’s Manual (Rev 2.0+)
Page 8 of 13
Reporting Changes to Compatible Automation Controller/Software
Thermostat Adapter will report the following changes to an INSTEON-compatible home automation
software once a change has been “stabilized” for at least 2 minutes:
• Temperature
• Humidity
• Thermostat mode
• Fan mode
• Set points
NOTE: Thermostat Adapter will only report changes to the last device it was Linked to, using the
instructions below. To change the interface to which you’d like the changes to be reported, follow the
“Enable” instructions with the new interface as the Responder.
While Thermostat Adapter will report to any automation controller or interface you Link to via the following
instructions, check the software’s documentation about compatibility with this feature.
Enabling Change Reports
1) Set the thermostat to Off mode
2) Press & hold the Set button on Thermostat Adapter for 3 seconds
The Thermostat Adapter Status LED will begin blinking
The thermostat display will flash all the LCD characters once
3) Press & hold the Responder’s Set button for 3 seconds
The Thermostat Adapter Status LED will stop blinking
The thermostat display will flash all the LCD characters once
Disabling Change Reports
1) Set the thermostat to Off mode
2) Press & hold the Set button Thermostat Adapter for 3 seconds
The Thermostat Adapter Status LED will begin blinking
The thermostat display will flash all the LCD characters once
3) Press & hold the Set button on Thermostat Adapter for 3 seconds again
The Thermostat Adapter Status LED will continue blinking
The thermostat display will flash all the LCD characters once
4) Press & hold the Responder’s Set button for 3 seconds
The Thermostat Adapter Status LED will stop blinking
The thermostat display will flash all the LCD characters once