Aluratek AIREC01F - Manual (Page 11)

12
Chapter 3: Configuration
Go to next
screen
Notes
1. POWER ON
The device is in
wired client mode
now. It already
connected to your
network.
Device is running
as a Wireless
Client.
Screenshot Instructions
2.
3.
3.2 Configure as a Wired Client
If there is no 802.11b/g wireless network, AIREC01F can also connect to
the wired network through an Ethernet cable.
For this case, prior to power on the device, you have to plug in the Eth-
ernet cable into the LAN (RJ45) connector on the back of the unit. After
you power on the device, it will automatically go into the wired client
mode when it detects a link status through the Ethernet connection.
First time using device with an Ethernet cable plugged in: