INTELLINET NETWORK 524827 GuestGate MK II User Manual - Manual (Page 23)

- 23 -
4. Access Control: Welcome Screen
Welcome Screen
Enable or disable the welcome page for guests. (Default = enabled.) If this parameter
is set to “disabled,” all guest users can access the Internet freely. No welcome page is
displayed, even if a guest password is defined below.
Global Guest Password
If you require your guests to enter a password to access the Internet, you can define it
here. If left empty, no password is required (default = no password). This is the global
password that can be used by any guest; it is not an individual user password. The
password option is only effective if the welcome screen option is set to “enabled” (see
above).
Radius Server
In case you have a RADIUS authentication server in your network and you want to
utilize it to authenticate your guest users, you need to enter the server’s IP address
here.
Radius Server
Type in the optional password for the RADIUS server here.
Radius Realm
Enter the optional realm delimiter (e.g., “@” or “\”) here.
5. Access Control: Welcome Passwords
Set up individual user passwords that are only valid for a certain time period and can
be used by a defined number of computers simultaneously. The example below shows
a password “test” that is valid from “05/28/2010, 12 am” until “06/02/2010, 12 am.” The
password can be used by five users simultaneously. Up to nine users can use the
same password. The amount of user passwords is limited by available memory in
GuestGate, but should ideally not exceed 20.