IQinVision Alliance-mx - Manual (Page 9)

9
11 Factory Reset
1. Press and hold the “Reset” button for 10 seconds as illustrated in Figure 11.1.
12 Complete the Dome Camera Installation
1. Attach the tether from the dome trim ring to the tether mounting point in the
enclosure as shown in Figure 12.1.
2. Rotate the black shroud inside the dome trim ring cover so it aligns with the
camera position.
3. Place the supplied desiccant pack inside the dome as shown in Figure 12.2 to
prevent fogging due to moisture that is present when installing the camera.
Use the supplied cable tie to keep the desiccant from falling down into the
dome bubble.
4. Attach the dome trim ring cover with shroud to the enclosure by tightening the
three tamper-proof screws with the supplied Torx T-20 security wrench.
13 PC Configuration of Alliance-mx
NOTE: The default user name for all IQeye devices is “root” and the default password is “system”.
IQeye cameras are configured for DHCP and will have an IP address assigned if
a DHCP server is on the network. If a DHCP server is not available, the camera
IP address will need to be configured using either IQfinder or IQmanager
depending on the number of cameras being installed.
Figure 11.1
Figure 12.1 Figure 12.2