IQinVision Alliance Series Pendant Mount - Manual (Page 5)

Alliance-mx
A. Make any cabling connections between the ceiling side and the Alliance-mx
camera.
B. Rotate the black shroud inside the dome trim ring cover so it aligns with the
camera position.
C. Place the supplied desiccant pack inside the dome to prevent fogging due to
moisture that is present when installing the camera. Use the supplied cable
tie to keep the desiccant from falling down into the dome bubble. Refer to the Alliance-
mx Installation and Operating Instructions for additional details.
D. Attach the dome trim ring cover with shroud to the
enclosure by tightening the three tamper-proof screws
with the supplied Torx T-20 security wrench (Figure 5.2).
NOTE: You can extend the camera lower from the ceiling by using standard 1-1/2” rigid conduit
available at any local hardware store.
5
Figure 5.2