AllerAir AR 4000 - Manual (Page 2)

1) Open the door and pull out
the pre-filters
Dus t filter
A W F D2424
W hite P re-filter
A W F P 2424
2) Untight the 4 wing-nuts
3) Pull out the HEPA or Carbon filter
as supplied
4) Close the door
AllerAir_MK :Manuals :QuickS tartAR 2000Dualpurpos e.pdf J an 09, 2006
HE P A
or
C arb
on
HEPA (AWFH0411) or
Carbon Filter(AWCF0500) -100 lbs
as supplied
C arbon filter
with HE P A only
A W C F 0314
If your unit is equiped with a pressure
gauge and a HEPA Filter, please follow
these instructions:
On the AirRhino 2000, The HEPA filter shoud
be changed when the gauge readsand above
1.7 inches W.C.
On the AirRhino 4000, with a new HEPA and
clean prefilters the gauge reads 1.6" W.C.
The HEPA shoud be changed when the gauge
reads 2.3" to 2.4".
S peed C ontrol or S witc h
P res s ure
G auge
or light
P anel Mount
C ontrol
Side View
Filter change diagram
AR 2000 and AR 4000
Dual Purpose Air Rhino Units
T oll free 1-888-852-8247
E -mail: info@ allerair.com
www.allerair.com
LINE 1
GROUND
LINE 2
FUSE 15A
MOTOR
GND
SPEED
CONTROL
WHT BLK
GRN
BLK
ORN
GRN
OR SWITCH
LIGHT
PS
(ONLY IN UNITS NOT EQUIPPED WITH GAUGE)
Electrical diagram
VOLTS 115 , AMPS 6.8
350W, RPM 1725
PH 1
THERMALLY PROTECTED
THERMALLY PROTECTED
VOLTS 115 , AMPS 3.3/2.8
PH 1
200W, RPM 1610/800
THERMALLY PROTECTED
VOLTS 115 , AMPS 15
PH 1
650W, RPM 1080
OR
OR
VOLTS 230 , AMPS 2.5
PH 1
RPM 900
OR