Alpine CDE-7856 - Manual (Page 7)

5
-EN
Subwoofer On and Off
(CDE-7859 only)
1
Press the SETUP button for at least 3 seconds.
2
Press the g DN or f UP button to select
the Sub-w mode.
3
Press the BAND button to select Subwoofer ON
or OFF.
4
After setting is completed, press the SETUP
button to return to normal mode.
NOTES
•
Initial mode is "Subwoofer ON."
•
Set to "Subwoofer OFF" unless the subwoofer is used.
•
When the subwoofer is turned on, the subwoofer
output level can be adjusted. For more details, refer to
the Adjusting Volume/Balance/Fader.
Subwoofer On and Off (CDE-7858/
CDE-7856 only)
1
Press and hold the c (Eject) button for at least 3
seconds.
With each press, subwoofer is toggled On or Off.
NOTES
•
Initial mode is "Subwoofer OFF."
•
Set to "Subwoofer OFF" unless the subwoofer is used.
•
When the subwoofer is turned on, the subwoofer
output level can be adjusted. For more details, refer to
the Adjusting Volume/Bass/Treble/Balance/Fader.
→
VOL
→
BAS
→
TRE
FAD
←
BAL
←
Adjusting Volume/Bass/Treble/
Balance (Between Left and Right)/
Fader (Between Front and Rear)
1
Press the MODE button repeatedly to choose
the desired mode.
Each press changes the modes as follows:
(CDE-7859)
(CDE-7858/CDE-7856)
NOTES
•
If the
5 or 6 button is not pressed within 5 seconds
after selecting the BASS, TREBLE, BALANCE, or
FADER mode, the unit automatically returns to the
VOLUME mode.
•
When the subwoofer is set to ON, the level of the
subwoofer can be adjusted.
2
Press the 55555 and 66666 buttons until the desired
sound is obtained in each mode.
NOTE
The settings of the Bass and Treble will be individually
memorized for each source (FM, AM and CD) until the
setting is changed. Depending on the connected devices,
some functions and display indications do not work.
Turning Loudness On/Off
(CDE-7856 only)
Loudness introduces a special low- and high-
frequency emphasis at low listening levels. This
compensates for the ear's decreased sensitivity to
bass and treble sound.
1
Press and hold the LOUD button for at least
2 seconds to activate or deactivate the loudness
mode.
The display shows "LOUD" when the loudness
mode is activated.
→
VOL
→
BAL
→
FAD