Ken Tool 30171 13 PC. HUBCAP & WHEEL LOCK REMOVAL KIT - Manual (Page 2)

WEAR ADEQUATE EYE PROTECTION WHEN USING THIS TOOL!
CLEAN THE GRIPPING SURFACES OF SOCKETS AND LOCKS.
30171-1 INSERT.PDF
W A R N IN G
30171 PARTS BREAKDOWN
LARGE GM TRIANGULAR WELL
HUBCAP LOCKS: Insert hex end of
tool into well. Turn with 3/4” wrench to
remove lock.
FORD & CHRYSLER HUBCAP
LOCKS: Drive tool onto lock. Turn
tool with a 3/4” socket to remove lock.
GM SPLINE HUBCAP LOCKS: Find the best-fit position and
slip or tap tool onto splined hubcap lock. Turn tool with a 3/4”
wrench to remove lock. Do not use an impact wrench with
30170-10
30170-20
30110-06 3” EXTENSION
STRIPPED 18MM NUTS, CORVETTE & GM WHEEL
LOCKS: Drive socket onto lock. Turn tool with a 1/2” drive to
remove lock.
19MM, 3/4” DAMAGED WHEEL LUG & OVERSIZED
WHEEL LOCK REMOVER: Place socket onto lock. Insert 3”
extension. Turn tool with a 1/2” drive to remove lock.
30171-10
30115-02
7/8” DAMAGED WHEEL LUG & OVER-
SIZED WHEEL LOCK REMOVER:
Place socket onto lock. Insert 3” exten-
sion. Turn tool with a 1/2” drive to re-
move lock.
30115-05
30170-60
GM WHEEL LOCKS & OVERSIZE AFTERMARKET WHEEL
LOCKS: Drive socket onto lock. Turn tool with a 1/2” drive to
remove lock.
GM HUBCAP LOCKS: Drive tool onto lock. Turn tool with a 3/4”
socket to remove lock.
30170-30
OVERSIZE AFTERMARKET WHEEL LOCKS: Drive socket
onto lock. Turn tool with a 1/2” drive to remove lock.
30170-70
GM HUBCAP LOCKS: Drive socket onto lock. Turn tool with a
1/2” socket to remove lock.
30170-40
LARGE DIAMETER CHRYSLER LOCKS: Drive socket onto
lock. Turn tool with a wrench to remove lock.
30170-90
FORD & GM WHEEL LOCKS: Drive socket onto lock. Turn tool
with a 1/2” drive to remove lock.
30170-50
EXTRACTOR PUNCH: Insert punch in 1/2” square drive hole.
Tap to remove lock from socket.
30170-80