Ken Tool 35449 T2001 Demount Tool - Manual

768 E. North Street • P.O. Box 9320 • Akron, Ohio 44305 Phone: 330-535-7177
Website: www.kentool.com E-mail: [email protected]
Fax: 330-535-1345
T2001 #35449 Demount Tool
Instruction Manual
Copyright 6/00
Demount First Bead
Break and lube both beads.
Lay tire on floor with short side
of wheel up. Hold curved part of large end,
with the tip facing up, behind
you. Keeping fingers out of the area
between tool and tire/wheel,
fully insert small end, between
rim and tire bead nearest you,
in top bead of tire.
Fully insert large end into gap
between wheel and tire until
you feel bottom bead. Lift small end, step through
the wheel and pull tool across
center of wheel. Push tool down to opposite
side. Tire is now fully
demounted.
Demount Second Bead
Lift large end. (Improper lifting
will cause the tool to roll) Step through the wheel and
pull tool across center of wheel. Push tool down to opposite
side. First bead is now
demounted. Remove tool from
wheel. Do not pick up
tire/wheel.