King Technology Aqua Smarte Plus Pool Awake! User Manual
Pool awake!™ operation instructions, It’s as easy as ready, set, go, For spring openings
3. AQUA SMARTE PLUS CANNONBALL!™
3. AQUA SMARTE PLUS CANNONBALL!™
Pool Awake!™
Operation Instructions
For Spring Openings
READY:
Start by removing
contaminants to keep
water crystal clear
SET:
Then set your
initial chlorine
level
GO:
Then prevent algae with
a 90-day algae
protection guarantee
Aqua Smarte Plus
Shine™
Aqua Smarte Plus
Optimize™
Aqua Smarte Plus
CANNONBALL!™
After using Aqua Smarte Plus Pool Awake!, insert your
Aqua Smarte Plus MizerMax Pac for continuous low-
chlorine maintenance for weeks at a time.
After using Aqua Smarte Plus Pool Awake!, insert your
Aqua Smarte Plus MizerMax Pac for continuous low-
chlorine maintenance for weeks at a time.
3. Insert upside down into center of
Aqua Smarte Plus Mineral Activator
pushing down firmly on key to
puncture seal.
3. Insert upside down into center of
Aqua Smarte Plus Mineral Activator
pushing down firmly on key to
puncture seal.
1. Turn off pump and turn dial to the
lowest setting and remove cap from
the Aqua Smarte or Aqua Smarte
Plus System.
2. Remove cap from Aqua Smarte
Plus CANNONBALL! without removing
seal.
1. Turn off pump and turn dial to the
lowest setting and remove cap from
the Aqua Smarte or Aqua Smarte
Plus System.
2. Remove cap from Aqua Smarte
Plus CANNONBALL! without removing
seal.
4
4
4. Replace cap by hand only.
DO NOT OVER TIGHTEN. Turn control
dial to Setting 5.
4. Replace cap by hand only.
DO NOT OVER TIGHTEN. Turn control
dial to Setting 5.
5. Turn pump on for 90 minutes allowing
Aqua Smarte Plus CANNONBALL! to
circulate through pool.
6. To remove Aqua Smarte Plus
CANNONBALL!, turn pump off, turn dial to
lowest setting, remove system cap.
7. Lift Aqua Smarte Plus CANNONBALL!
up and allow any water in the container to
drain through the system before recycling
or discarding in trash.
NOTE: If water shows more than a hint of
blue inside Aqua Smarte or Aqua Smarte
Plus System, replace the cap, turn dial
to Setting 5 and run the pump for one
minute.
8. If pool size requires additional Aqua
Smarte Plus CANNONBALL!, repeat steps
1-7.
5. Turn pump on for 90 minutes allowing
Aqua Smarte Plus CANNONBALL! to
circulate through pool.
6. To remove Aqua Smarte Plus
CANNONBALL!, turn pump off, turn dial to
lowest setting, remove system cap.
7. Lift Aqua Smarte Plus CANNONBALL!
up and allow any water in the container to
drain through the system before recycling
or discarding in trash.
NOTE: If water shows more than a hint of
blue inside Aqua Smarte or Aqua Smarte
Plus System, replace the cap, turn dial
to Setting 5 and run the pump for one
minute.
8. If pool size requires additional Aqua
Smarte Plus CANNONBALL!, repeat steps
1-7.
553081243R2N 20-48-0262
553081243R2N 20-48-0262
SHINE
“
Eliminates Contaminants for
Crystal Clear Water
OPTIMIZE
™
Establish an Initial Chlorine
Level with Precise Feeding
It’s as easy as Ready, Set, Go!
King Technology, Inc.
530 11th Ave S, Hopkins, MN 55343 • 952-933-6118 • FAX 952-933-2206 • www.kingtechnology.com
Pool Awake!™
Operation Instructions
For Spring Openings
READY:
Start by removing
contaminants to keep
water crystal clear
SET:
Then set your
initial chlorine
level
GO:
Then prevent algae with
a 90-day algae
protection guarantee
Aqua Smarte Plus
Shine™
Aqua Smarte Plus
Optimize™
Aqua Smarte Plus
CANNONBALL!™
SHINE
“
Eliminates Contaminants for
Crystal Clear Water
OPTIMIZE
™
Establish an Initial Chlorine
Level with Precise Feeding
It’s as easy as Ready, Set, Go!
King Technology, Inc.
530 11th Ave S, Hopkins, MN 55343 • 952-933-6118 • FAX 952-933-2206 • www.kingtechnology.com
(see website below for guarantee details)
(see website below for guarantee details)
90
MIN
90
MIN
After Aqua Smarte Plus Shine and Aqua Smarte Plus
Optimize have dispensed, test the water before adding Aqua
Smarte Plus Cannonball! for a 90-day algae-protection guar-
antee. When the pH is between 7.2 and 7.8 and the chlorine
level is no more than 4.0 ppm, follow steps 1-8 below.
After Aqua Smarte Plus Shine and Aqua Smarte Plus
Optimize have dispensed, test the water before adding Aqua
Smarte Plus Cannonball! for a 90-day algae-protection guar-
antee. When the pH is between 7.2 and 7.8 and the chlorine
level is no more than 4.0 ppm, follow steps 1-8 below.
U.S. Patent Numbers: D410,520; 6,210,566; 6,544,415; 6,814,095;
6,948,510 and other U.S. and Foreign patents pending.
U.S. Patent Numbers: D410,520; 6,210,566; 6,544,415; 6,814,095;
6,948,510 and other U.S. and Foreign patents pending.
NOTE: Avoid adding other chemicals until this
product has been circulated (filtered) for at least
24 hours.
NOTE: Avoid adding other chemicals until this
product has been circulated (filtered) for at least
24 hours.