Kolpin 98005 – Throttle Master - Manual

Rev. 3
98005 – Throttle Master
Mounting Specific Instructions:
1. Place the Throttle Master over your existing throttle on your ATV.
2. Place the ¼” Truss Head Bolt through the holes in Mounting Base. Tighten enough to
hold the Throttle Master on your throttle.
3. Check the location of your new Throttle Master. You can slide the Throttle Master
Section outwards to obtain more leverage.
4. Once proper location is achieved, tighten down the Mounting Base securely to the OEM
throttle.
5. Place the Rubber Caps over the extra threads that protrude out past the backside of the
Mounting Base.
**Warning**
- With the machine off, check the function of your Throttle
Master. You may have to cut your handle bar grips to ensure there is no
interference when using the Throttle Master. Your throttle could become
“stuck” open and could result in serious injury or death!
NO. DESCRIPTION QTY.
1 MOUNTING BASE 1
2 THROTTLE MASTER 1
3 ¼” TRUSS HEAD BOLT 2
4 ¼” LOCK NUT 2
5 RUBBER CAP 2
Kolpin Outdoors, Inc.
205 N. Depot Street, Fox Lake, WI 53933
Phone #: (877) 9KOLPIN or (920) 928-3118
www.kolpinpowersports.com
[email protected]
Interference – Trim with
knife or scissors!