Kolpin 86100 – Chisel Plow_Scarifier - Manual

Rev. 2
86100 – Chisel Plow/Scarifier
Kolpin Outdoors, Inc.
205 N. Depot Street, Fox Lake, WI 53933
Phone #: (877) 9KOLPIN or (920) 928-6514
www.kolpinpowersports.com [email protected]
NO. Description QTY.
1 Blades 6
2 Brackets 6
3 Bolts 6
4 Nylock Nut 6
5 Washer 6
6 5/8” x 3” Bent Hitch Pin 6
7 R-Pin 6
1
2
Chisel Plow/Scarifer Use:
This product is designed to dig up hard packed surfaces such
as, gravel driveways, soil, and clay.
This product can be used in conjunction with the Kolpin Rear
Blade or Kolpin Box Scraper.
Kolpin Toolbar required to use Chisel Plow/Scarifer.
Mounting Specific Instructions:
1. Slide the six Brackets onto the Kolpin Toolbar, as shown in
the picture. Attach using the (6) Bolts, Nylock Nuts, and
Washers provided. Place three brackets on one side of the
vertical tube on the Kolpin Toolbar. Place the other three
brackets on the other side.
2. Leave enough room that you are able to slide the Toolbar off
of the lift arms of the Kolpin 3-Point unit.
3. Once you have your spacing correct, tighten securely.
4. Drop the Chisel Plow/Scarifer Blade through the vertical slot
in the bracket. You will notice that the blade comes with a
series of holes. The lowest hole is for transporting the blade.
The other holes in the blade are there for a quick adjustment
of different depths.
5. Final set up should look similar to the picture.
DIRECTION OF PULL