Kolpin 86850 – TOW BEHIND DISC - Manual

Rev. 1
86850 – TOW BEHIND DISC
Tow Behind Disc Assembly:
1. Bolt the Toolbar to the Tongue Tube Weldment, using (1) 5/8” x 3.50” Hex Head
Bolts, (2) 5/8” Washers and (1) 5/8” Nylock Nut! Snug together. Do not over
tighten as this will not allow the Toolbar to pivot. To secure the Toolbar from
pivoting you must use the 5/8” x 3.00’ Bent Hitch Pin, as shown below. There
are also three settings located on the base of the Tongue Tube, which allows you
to adjust your disc to better accommodate your ATV!
DESCRIPTION QTY. Spare P/N
Tongue Tube Weldment 1
Toolbar Weldment 1
Handle Tube 1
Weight Tray 2
12” Tires 2
5/8” x 3.00” Bent Hitch Pin 2
R-Clip 2
Lynch Pin 2
5/8” x 3.50” Hex Head Bolt 3
DESCRIPTION QTY. Spare P/N
5/8” Nylock Nut 3
5/8” Washers 6
5/16” x 1.50” Hex Head Bolt 4
5/16” Nylock Nut 4
5/16” Flat Washer 8
1” Washer 2
1” Plastic Cap 1
2” Plastic Cap 1
Round Plastic Cap 1
Toolbar Weldment
5/8” Bent Hitch Pin
5/8” Hex Head Bolt