Kolpin 21510 - Rhino Grip XL - Manual

Rev. 1
21510 - Rhino Grip XL
No. Description QTY. Spare P/N
1 Plastic Mounting Base 2 71514
2 Metal Backer Plate 2 71513
3 Rhino Grip 2 71511
4 Adjustment Knob 2 71501
5 Clip 2 71509
6 Rubber Strap 2 87010
7 ¼” – 20 x 2.25” Truss Bolt 8
8 ¼” – 20 x 1.50” Truss Bolt 8
9 ¼” – 20 Nylon Nut 8
10 Rubber Caps 8
Mounting Instructions -
1. Position the Rhino Grip mounting base on the roll bar/rack where desired.
2. Run the ¼” bolts provided through the main base and through the backer plate. Secure with nylon
nut. Repeat three more times.
3. Tighten the (4) ¼”-20 x 2.25” (UTV) or 1.50” (ATV) truss head bolts evenly. Note: Be sure not to
over tighten the bolts, as too much torque can over stress the base and cause the grip to fail.
4. Insert the Rhino grip into the mounting base and position as desired. NOTE: Grip can rotate 360°
to accommodate any angle, and the grip can tilt 0° to 180° at 45° increments.
5. Secure the grip to the mounting base using the plastic clip provided.
6. Repeat on opposite side of vehicle.
5
2
3
1
Kolpin Outdoors, Inc.
205 N. Depot Street, Fox Lake, WI 53933
Phone #: (877) 9KOLPIN or (920) 928-3118
www.kolpinpowersports.com c[email protected]
These grips are designed to quickly and easily mount
to the rear rack or roll cage of an ATV or UTV-they will
fit any tubing size from Ø7/8” to Ø2.00”! Note:
Hardware provided is based on the biggest tube
diameter. You are required to cut the excess threads
from the grip once installed. Failure to do so may
result damage to your machine. Note: The grip can
be used in the vertical and horizontal positions.
To tilt the grip simply loosen the
adjustment knob, tilt the grip to the
angle of your choice, and retighten.
4