KT&C KPC-ND521NU - Manual (Page 2)

“When installing the camera, to insure reliable operation please seal well/protect the
power and video connections from moisture.”
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.”
WARNING
This is a class A product. In a domestic environment this product may cause radio interference in which case the
user may be required to take adequate measures.
Caution
Any changes or modifications in construction of this device which are not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
1. To obtain best picture quality and most stable operation, a regulated DC12 500mA
power supply is recommended to power this camera.
An unregulated power supply may
damage to the camera, and its use may void the product warranty.
2. It is recommended that the camera is used with a monitor that has a CCTV quality
75 video impedance level.
If your monitor is switched to high impedance then please a djust accordingly.
3. Do not attempt to disassemble the camera to gain access to the internal components.
Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or reflective light, which may
cause smear on the picture and possible damage to the CCD.
5.
Do not remove the serial number sticker; it is required to obtain warranty service.
DIMENSIONS
CONNECTION
CAMERA MOUNTING POSITION
Unit : Inches (mm)
Tapping Screws-4x25L(4ea)
Plastic Anchors (4ea)
Template
<Front View>
Approx. 2.76” (70 mm)
20 - IR LED
Ø 3.66” (93 mm)
<Top View>
4 - Ø 0.18” (4.5 mm)
2.69” (68.5 mm)
<BOTTOM View>
Ø 2.72” (69 mm)
<Side View>
3.31” (84 mm)
(The maximum rotation)
Open
Close
Tiilt: 70° Tiilt: 70° 140°
CCTV Camera
DC12V
(DC Jack)
DC12V
Adapter
TV
Monitor
BNC Female
Video In