Chapin 19069 - Manual

Hazard: Improper use or failure to follow instructions can result in explosive failure
causing serious eye or other injury. For safe use of this product you must read and follow
all instructions. Do not leave a pressurized sprayer in the hot sun. Heat can cause pressure
build-up. Do not store or le ave solution in tank after use. Always wear goggles, gloves, long
sleeve shirt, long pants and full foot protection when spraying. Never use any tool to remove
pump if there is pressure in sprayer. Never stand with face or body over top of tank when
pumping or loosening pump to prevent ejecting pump assembly and/or solution from strik-
ing and injuring you. Never pressurize sprayer by any means other than the original pump.
Do not attempt to modify or repair this product except with original manufacturer’s parts.
Never spray flammable materials or heat, pressure, or gas producing chemicals. Always
read and follow manufacturer’s instructions before use with this sprayer as some chemi-
cals may be hazardous when used with this sprayer.
WARNING!
Sk-1113-1
Repair Parts Kit Gaskets and Seals (not included),
Juego de piezas de reparación, empaquetaduras y juntas (no incluido)
Kit de pièces de réparation, joints et garniture d’étanchéité (non inclus) 6-4646
Printed in U.S.A.
1) Do: Check tightness of hose nut to be sure hose is securely attached to the tank outlet.
2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of these conditions are
found, replace hose before using. Replace with original manufacturer’s parts only.
3) Do: Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and
exterior of tank for signs of deterioration of body and bottom. Any sign of deterioration
indicates possible tank weakening and could result in explosive bursting under pressure. If any
of these signs are found, discard tank immediately and replace. Do not attempt to patch leaks,
etc., as this could result in serious injury.
4) Do: Follow Filling, Pressurizing and Spraying Instructions, except use water only.
5) Do: Pump plunger 8-10 strokes and inspect for leaks.
6) Do: Direct shut-off away from you and open to make sure discharge is not clogged.
7) Do: If unit passes this test, release pressure (see Pressure Releasing Instructions), empty tank,
and proceed with Filling, Pressurizing and Spraying Instructions.
3. Pre-Use Check
4. Filling
1) Do: Turn pump handle counterclockwise and remove pump
2) Do: Prepare spray solution following all directions and safety warnings on chemical label.
3) Do: Fill tank to no more than the proper gallon marker. Do NOT: overfill to accommodate
pump.
4) Do: Check pump to make sure that no grass or dirt is stuck to barrel. Replace pump in tank
and tighten securely.
8. Care, Storage and Maintenance
1) Do: Rinse tank thoroughly with water only, empty, refill with water. Follow Filling,
Pressurizing and Spraying Instructions, except pump unit only 8-10 strokes.
2) Do: Open shut-off and allow water to run through discharge assembly.
3) Do: Release pressure (Follow Pressure Release Instructions), remove pump and empty sprayer.
4) Do: Store sprayer tank upside down, with pump removed, in a warm dry location.
5) Do: Periodically oil pump by dropping 10-12 drops of light oil down pump rod through
opening in cover.
WARNING: Handling the brass parts of this product will expose you to lead, a chemical
known to the State of California to cause birth defects and other reproductive harm. Wash
hands after handling.
010325-8 (A) R0209
1. Hose to Tank
2. Nozzle
Parts, Piezas, Pièces
Note: Your particular sprayer may not include all parts pictured above.
Nota: Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.
Remarque : Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.
Attach the hose by screwing the swivel
nut clockwise and tightening to 37 in.
lbs. Refer to Pre-use check before using.
Attach nozzle to shut-off handle or extension wand.
TO LOCK HANDLE: Push handle down to depress coil
spring and turn handle 1/4 turn clockwise, then allow handle
to raise into lock position.
5. Pressurizing and Spraying
5A
Lock
Position
5B
TO RELEASE HANDLE: Push down to depress coil spring and
turn handle counterclockwise 1/4 turn, then lift handle.
Pump until you feel resistance.
TO LOCK PUMP: Place pump prongs down into
slots in funnel, turn clamp clockwise to furthest posi-
tion under bottom slot, then turn handle clockwise
until tightly locked and sealed in place.
TO UNLOCK PUMP: Turn handle counterclockwise until
3-prong clamp is loose. Then rotate clamp counterclockwise to stop
and lift out.
5C
5D
5. Pressurizing and Spraying, continued
5E
5F
1A
2A 2B
For constant spraying, push down on shut-off
handle and move locking mechanism away from
you. To release, squeeze handle and move the lock-
ing mechanism back towards you.
6. Fatigue-Free Spraying
7. To Release Pressure
1 Do: With pump facing away, turn locked handle counterclockwise until air begins to
escape. Stop turning handle when you hear air escaping.
2) Do: Stay away from the sprayer until all air has escaped.
6A
6-6092
Hose Black
Manguera para trabajos pesados Negro
Tuyau pour service intense Noir
6-5380
Shut-off Handle
Mango de cierre
Poignée du robinet
6-5943
Nozzle 1.0 GPM
Tobera
Buse
6-7703
Extension wand, Vara de extensión, Rallonge
6-5797
Nozzle .5GPM
Tobera
Buse
6-5373
Holster
Funda
Étui
Congratulations!
You have just purchased a quality Chapin product.
Register Your Sprayer Online @ www.chapinmfg.com
Questions?
Do Not Return To Store.
Call us @ 1-800-950-4458 or www.chapinmfg.com
¡
Felicitaciones!
Usted acaba de adquirir un producto de calidad Chapin.
Registre su pulverizador en línea en www.chapinmfg.com
¿Preguntas?
No regrese a la tienda;
llámenos al 1-800-950-4458 o visite www.chapinmfg.com
Félicitations!
Vous avez acheté un produit de qualité Chapin.
Enregistrez dès que possible votre pulvérisateur en ligne à l'adresse suivante:
www.chapinmfg.com
Questions ?
Ne retournez pas au magasin.
Appelez-nous 1-800-950-4458 ou visitez le www.chapinmfg.com