Clock Audio SM 80S-RF - Manual (Page 2)

SM 80S-RF
www.clockaudio.com
Installation guide
1) Ensure minimum table thickness of 25mm
(1”).
2) Drill a 50mm (2”) hole through the table
see fig A.
3) Remove the 3 M3 pan headed screws from
the bottom plate see fig B.
4) Remove the 2 M3 x 30mm pan headed
screws securing the base plate to the top
assembly see fig C
5) Select the LED voltage by moving the
jumper to the required position see fig D.
6) Fit the top assembly through the 50mm
(2”) hole see fig E.
7) Re-fit the base plate to the assembly using
the 2 M3 x 30mm screws adjusting the
nuts to clamp the top assembly and the
bottom plate to the table ensuring that the
top assembly is correctly aligned before
finally tightening the nuts see fig F.
8) Re-fit the bottom plate to the shock
mounts using the 3 M3 pan headed screws.
Adjust the height of the PPA-RF and secure
with nut supplied see fig G.
9) Installation complete see fig H.
Fig H
Fig G
Fig F
Fig E