CNB IGP2035F - Manual (Page 40)

XNET User Manual
40 / 50
ITEM DESCRIPTION
Event Enable Enable Event Enables or disables event processing.
Event Mode
Sensor Enables or disables the Alarm sensor.
Motion
Detection
Enables or disables Motion Detection.
Network
Linkdown
Enables or disables Network Linkdown.
Event Settings
Capture Format
This displays the capture format of images or video for an event
recording.
Sub Stream Codec Save as
H.264 Video
MJPEG Image
Capture Frame
When processing an event, this displays the recording frame rate of
image or video.
Sub Stream Codec Recording Frame Rate
H.264 The same as Sub Stream Frame rate
MJPEG 1 image per second
Pre-Alarm
When processing an event, this establishes saving images or video
before the occurrence of the event.
It can be saved MAX 5 seconds before the event.
Post-Alarm
When processing an event, this establishes saving images after the
occurrence of the event.
It can be saved MAX 8 seconds after the event.
Event Output
Alarm Output
Port
This sends out Alarm signal to its output port during event processing.
Upload image
to FTP
This allows Alarm images to be uploaded to an FTP server when
processing an event. The client PC has to run FTP server to receive
the images, and the information of the FTP server has to be
accurately entered and saved at the FTP Configuration page.
Send Image to
Email
This allows Alarm images (Not Video) to be sent out by an e-mail
when processing an event. Only one image file at the moment of the
event gets sent out. The e-mail address has to be accurately entered
and saved at SMTP configuration page.
Save image to
SD memory
This allows Alarm images to be saved to SD card when processing an
event.
View
Open Load Saved images through FTP
Port Specify internal FTP server port
Save - Applies and saves changes.
Reset - Recalls previously saved configurations.