CNB IXP3035VR - Manual (Page 20)

XNET Network Weatherproof Camera Installation Manual
20 / 23
4. Using Web Viewer
You can connect to the XNET camera using your internet browser or a software called “XNET-CMS”. This
section covers the connection through your web browser only. For instructions on how to configure the
network connection using the
XNET-CMS software, please refer to the manual for the XNET-CMS, which can
be found in the installation CD.
4 4 . . 1 1 . . L L o o g g g g i i n n g g I I n n
Enter the IP address of the XNET camera on the address bar of your web browser.
Then the following webpage will appear:
Figure 4-1. Log-in Box
Enter the user name and password to go to the web viewer page. The default id and password is “root”
and “admin”. If you have changed the HTTP port number from the default value, put a colon and the
port number at the end of the IP address. (For example, enter the following address when you changed
the port to 8080: http://192.168.123.100:8080)
<Address format for accessing as an administrator>
(When using the default IP address and port number) http://192.168.123.100
(When the IP address and port number have been changed) http://IP address: new port number
If you forget the administrator’s password, “Factory Reset” is the only way to regain
access. However, since this will retrieve all default settings, the network settings
have to be configured again using the IP installer.
For security, please change the administrator’s id and password from their default
values. Please save the changed ID and password in a place only accessible by an
administrator. Please refer to
[Web Viewer Manual] for detail .