CNB IJB2000 - Manual (Page 25)

XNET User Manual
25 / 39
ITEM DESCRIPTION
IPv4 Address
Configuration
Enable DHCP
Turns DHCP on or off.
Check DHCP checkbox to get an IP address automatically from the
network using DHCP protocol. Obtained IP address can be viewed by
IP Installer.
(Note) If the network does not use DHCP server, the product will wait
for server’s response for two minutes and restart with its previous IP
address.
IP address
Enter an IP address.
Configure IP address after checking IP address range configuration of
the router where the XNET product is connected.
Subnet mask
Enter Subnet mask.
Use this when you want to access only from the same subnet by
masking out upper portion of the IP address.
Use 255.255.255.255 when you want to connect from one PC only.
Default router Enter the address of Default router.
DNS
Configuration
Domain name Enter Domain name.
Primary
DNS Server
Enter primary DNS address.
Secondary DNS
Server
Enter secondary DNS address.
NTP
Configuration
Network
address
Enter address of NTP (Network Time Protocol Server.)
NTP server is used when “Synchronize to NTP Server” is selected in
Date&Time page.
Host name
Configuration
User
the host name
Enter Host name
Ethernet
Address
Ethernet
address
Enter Ethernet Address.
Save - Applies and saves changes.
Reset - Recalls previously saved configurations.