CNB SDN-23Z27FW - Manual (Page 26)

XPEED Outdoor Series WWW.CNBTEC.COM
4. OSD Menu
26
■ ALARM ACTION SETUP
Sets the preset to move to when the alarm is input.
• ALARM N ACT [NOT USED/PRESET 1~128]
Assign counteraction Preset position to each Alarm input
⊙
Preset Setup
• PRESET NO. [1~128]
If a selected preset is already defined, camera moves to pre-defined
position and preset characteristics such as Label and Relay Outputs show on
monitor. If a selected preset is not defined, “UNDEFINED” shows on
monitor.
• CLR PRESET
[CANCEL/OK]
Delete current Preset data.
• EDIT SCENE Redefine current Preset scene position (i.e.PTZ).
• EDIT LABEL Edits Label to show on monitor when preset runs.
MAX. 10 alphabets are allowed.
• RELAY OUT Sets the relay output. The figure on the right is current Setting value. '-'
indicates OFF mode.
If the relay is shown as figures, it means relay is ON.
• CAM ADJUST [GLOBAL/LOCAL]
WB(White Balance) and AE(Auto Exposure) can be set up independently
for each preset. There are 2 modes, “Global” mode & “local” mode.
The Global mode means that WB or AE can be set up totally and
simultaneously for all presets in “ZOOM CAMERA SETUP” menu.
The local mode means that WB or AE can be set up independently or
separately for each preset in each preset setup menu. Each Local
WB/AE value should activate correspondingly when camera arrives at
each preset location.
During jog operation, Global WB/AE value should be applied.
All Local WB/AE value should not change although Global WB/AE value
changes. If “local” is selected, Menu to set WB/AE shows on monitor.