CNB S1965PX - Manual (Page 6)

XPEED Indoor Series WWW.CNBTEC.COM
6
1. Introduction
⊙ Parts Name & Functions
① Bubble If the bubble is damaged or soiled by scratching or foreign matters, the damaged/dirty part will be visible on the
screen.
Therefore, do not undo the protective cover until the installation is complete.
② Mounting Base The mounting base is to used to install the camera onto the ceiling or camera brackets.
Disassemble the mounting base first and install it onto ceiling or brackets and then assemble it with the main body.
③ Anti-drop
Spring & Hook
This is used to prevent the main body of camera from dropping during installation.
Attach the anti-drop spring to the hook when assembling the main body to the mounting base.
④ TORX Screw When the main body and the mounting base are assembled, be sure to insert the screw to the mounting base,
otherwise there is a risk of the main body dropping from the mounting base by vibration, jarring or movement.
⑤ Fuse If a fuse is blown by over-voltage current, change it with a new one, and contact the manufacturer or dealer to check
the cause of the over-voltage and remove it.
The breaking capacity of a fuse is 250V, 2A
⑥ Cabling
Terminal Block
During installation, Power, Video, Communication, Alarm I/O cables are connected on to this cabling terminal block.
⑦ Main Connector With this connector, I/O board mounting base and the dome drive are connected.
⑧ Mounting Hole Fastening the mounting base to the ceiling or camera brackets using the three mounting screws provided.