CNB MP258VD - Manual

Signal System
Scanning System
Scanning Frequency (H)/(V)
Image Sensor
Total Pixels No.
S/N Ratio
Resolution
Lens
Focus
Sensitivity
Electronic Shutter
AGC / BLC
Input/Output Connector
Power Consumption NTSC : 525 Lines PAL : 625 Lines
2 : 1 Interlace
15.734kHz / 59.94Hz 15.625kHz / 50Hz
1/3 inch SONY IT CCD
410K [Normal: 270K] 470K [Normal: 320K]
More than 48dB
480 TV Lines / 380 TV Lines
Fixed Lens / Pin Hole Lens
Manual
0.3 Lux(High) / 0.1 Lux(Normal)
1/60~100,000 Sec. 1/50~100,000 Sec.
On / Off Selectable
Power(Red Jack), Video(Yellow Jack)
DC 12V (DC 9V~15V) / 3W (Max)
!
USER INFORMATION:
PRECAUTION:
CAUTION! TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
When this camera is installed near wireless communication devices that emits strong electromagnetic field, irregularity such as noise
on the monitor may appear.
THE GRAPHIC SYMBOLS WITH SUPPLEMENTAL MARKING ARE ON THE BOTTOM
OF THE SYSTEM.
"WARNING-TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT
TO RAIN OR MOISTURE"
The lightning flash with arrowhead symbol, within an equilateral
triangle, is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance-
(servicing) instructions in the literature accompanying the appliance.
Explanation of two Symbols
P/N:3810-0073B ver.0604E
This manual explains the installation and operating method for the
color dome camera. Before installation, make sure you are familiar
with this product's special features and proper operating technique.
INSTALLATION: Dimensions(mm):
SPECIFICATIONS:
Design and specifications
are subject to change
without notice.
Own er's
Man ual
COMPOSITION:
Wall Mounting
Screw
Wall
Bracket
Bracket Screw Miniature
Camera
CONNECTION:
No.
#1
#2
Function
Video Output
Power Input
Remark
1.0 Vp-p
DC12V(10V~15V),
Terminal Color
Yellow
Red
• The wire is polarized.
• Use DC 12V power source.
DC 12V Power Source
BLC OFF BLC ON AGC OFF AGC ON
NO
1
2
L H
L H
DC 12V GND V-OUT
39.0
37
.0
37.0
32.25
24.75 2.35
DC 12V GND V-OUT
20.17 2.35
TO REDUCE THE RISK
OF ELECTRIC SHOCK DO
NOT REMOVE COVER.
This equipment has been tested and found to comply with limits for a
Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct
the interference at their own expense.
※ Recommendable Power Supply
(DC 12V/ Over 0.3A Power Adapter)
#1
#2
Video
(Yellow)
Power
(Red)
Video Output
GND
Power(+)
GND
Scanning System
Scanning Frequency (H)/(V)
Image Sensor
Total Pixels No.
S/N Ratio
Resolution
Lens
Focus
Min, Illumination
Electronic Shutter
Input/Output Connector
Power Consumption EIA CCIR
2 : 1 Interlace
15.734kHz / 59.94Hz 15.625kHz / 50Hz
1/3 inch SONY IT CCD
768(H)x494(V) [Normal:510(H)x492(V)] 752(H)x582(V) [Normal:500(H)x582(V)]
46dB (AGC Off)
570 TV Lines / 380 TV Lines
Fixed Lens / Pin Hole Lens
Manual
0.2 Lux(High) / 0.1 Lux(Normal) : F1.2, 20IRE
1/60~100,000 Sec. 1/50~100,000 Sec.
Power(Red Jack), Video(Yellow Jack)
DC 12V (DC 9V~15V) / 1.5W
Pin Hole Lens
Fixed Lens
CCD B/W Type
CCD Color Type
camera specialty
CCD Camera Miniature
Miniature Digital DSP
1/3" SONY CCD
LENS .Fixed
.Pin Hole
CCD .COLOR
.B/W
32x32