CNB VB1750PIR - Manual

Design and specifications are
subject to change without notice.
Eyeball Eyeball
Vandal Vandal
Resistant Resistant
Dome Camera
EyeBall Vandal
INSTALLATION INSTALLATION
This manual explains the installation and operating method
for the color dome camera. Before installation, make sure you are familiar with this product's special features and
proper operating technique.
TROUBLE SHOOTING TROUBLE SHOOTING If you have troble operating your camera, refer to
the following. If the guidelines do not enable you to solve
the problem, contact an authorized technician.
COMPOSITION COMPOSITION
Check the power source for the monitor and camera and assure that the voltage and polarity are properly
connected and being supplied correctly.
Check if the lens is stained.
If dirty, clean the lens with a soft, clean cloth.
Adjust the Back Focus of the lens again.
Check if you have connected the camera to a proper
power source and if there is no problem with the power,
turn the unit off immediately and seek assistance
from our After Service department.
Check if the camera is pointed toward the sun or a
fluorescent lamp.
Adjust the angle or location of the camera if too much
light is comming into the screen.
CONNECTION CONNECTION
The camera does not work
properly, the surface of the
camera case is hot, and
a black line appears on
the screen.
The screen blinks a lot.
The image on the
screen is dim.
The image does not appear
on the screen.
DIMENSIONS(mm) DIMENSIONS(mm)
GND
Video Output
GND
Power (+)
Video Video/Yellow
Power Power/Red
Function Terminal Color
Video Output
Power Input Yellow
Red
Dome Ø 70
BASE HOUSING
EYEBALL CAMERA
STOPPING RING
DOME COVER
FIXING
SCREW
MOUNTING SCREW
OWNER'S MANUAL DOME CAMERA MOUNTING SCREW
GUIDE PATTERN
Guide Pattern
L-WRENCH
Put the dome cover over the base housing and turn it clockwise by hand.
Adjust desired scene by turning and moving the eyeball camera and fix
it with stopping ring.
Fix the base housing to the desired place with screws supplied.
To fix dome cover tight, use the fixing screw.
O O
WNER'S WNER'S
MANUAL MANUAL
Full Eyeball Camera Angle Adjustment
E Y E B A L L E Y E B A L L
Ш94
51.1 63.7
26.6
Ш70
PRECAUTION PRECAUTION
Keep enough space around the unit for ventilation.
Slots and openings on the monitor should not be blocked.
To reduce the risk of fire or electric shock, do not expose this appliance
to rain or moisture.
Remove the plug from the outlet before cleaning. Do not use liquid
aerosol detergents. Use water damped cloth for cleaning.
Do not attempt to service this unit yourself as opening or removing
covers may you to dangerous voltage or other hazards. Please refer
all servicing to qualified service personnel.
During flashes of lightning or cracks of thunder, or when the system
is not used for a long time, unplug the system power supply to protact
the unit from lightening or power surges.
All the warnings and instructions of this manual should be followed.
Do not place anything on top of the unit that might spill or fall into it.
USER INFORMATION USER INFORMATION
CAUTION! TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral traingle,
is intended to alert the user to the presence of un-insulated"dangerous voltage"
within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral traingle, is intended to alert the
user to the presence of important operating and maintenance-(servicing)
instructions in the literature acompanying the appliance.
THE GRAPHIC SYMBOLS WITH SUPPLEMENTAL MARKING ON THE BOTTOM OF THE SYSTEM.
"WARNING-TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN
OR MOISTURE"
CAUTION CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
SPECIFICATIONS SPECIFICATIONS
Signal System
Scanning System
Scanning Frequency(H)
Scanning Frequency(V)
Image Sensor
Total/Effective Pixels No.
S/N Ratio
Resolution
Video Output Levels
Lens
IR LED & Sensor
Sync. System
Min. Illumination
White Balancce
Gain Control
Input/Output Connector
Supplied Voltage
Power Consumption
Dome Size (Ø)
Weight
NTSC : 525 Lines
15.734kHz
59.94Hz
410K/380K [Nomal:270K/250K]
Auto (AWB)
Auto (AGC)
70mm
Model NTSC
PAL : 625 Lines
2 : 1 Interlace
50Hz
15.625kHz
1/3 inch SONY Super HAD CCD
470K/440K [Nomal:320K/290K]
More than 48dB (AGC off)
1.0 Vp-p (75 Ohms, composite)
Fixed Lens : f=4.3mm, 6mm(Option)
Internal
0.3 Lux (High) / 0.1 Lux (Normal) / 0 Lux (IR LED On)
Power (Red Jack), Video (Yellow Jack)
IR LED (24EA), Sensor (1EA)
350mA (Max. 4.2W)
10V DC ~ 15V DC (Recommendation 12V DC±0.5V DC)
Approx. 434g
PAL
P/N: 3810-0126B (ver.0804E)
FIXING SCREW
CAMERA
VANDAL
DOME
EYEBALL EYEBALL
CAMERA
VANDAL
DOME
PLASTIC ANKER
120°
50.2
58
Ø45.8
12V 12V DC DC Power Power Type Type
530 TV Lines /480 TV Lines / 380 TV Lines