CNB BP258IR - Manual

.
Dimensions (mm)
.
Accessory
.
Specifications
P
/
N
: 3
8
1
0
-0
0
2
9
A
D e s i g n a n d s p e c i f i c a t i o n s a r e s u b j e c t t o c h a n g e w i t h o u t n o t i c e .
Model
Image Sensor
Total/Effective Pixels No.
S/N Ratio
Resolution
Video Output
Lens
Angle of View
Sync System
Sensitivity
Shutter Speed
White Balance
AGC
IR LED/SENSOR
LED Lighting Distance
Input/Output Connector
Supplied Voltage
Power Consumption NTSC PAL
1/3 inch SONY Super HAD CCD
270K / 250K 320K / 290K
More Than 48dB (AGC Off)
Horizontal : 380 TV Lines
1.0 Vp-p (75 Ohms, Composite)
Fixed (Without IR LED : f=3.8mm, With IR LED : f=6.0mm)
f=3.8mm : 88º / f=6.0mm : 60º
Internal
0 Lux (With IR LED), 0.1 Lux (Without IR LED)
1/60 ~ 100,000 Sec. 1/50 ~ 100,000 Sec.
Auto
Auto
Option : 850nm 9EA, CDS Sensor 1EA
10m
Power (Red Jack), Video Output (Yellow Jack)
DC 10V ~ 14V (Recommendation DC 12±0.5V)
Less Than 200mA, 2.0W (Max)
.
CAUTION
.
Regulatory Notice
Do not install the camera in extreme temperature conditions.
Do use the camera under conditions where temperatures are within -10°C to 50°C.
Especially be careful for ventilation under high temperature.
Do not install or use the camera in an environment where the humidity is high.
It can cause the image quality to be poor.
Do not install the camera under unstable lighting conditions.
Severe lighting change or flicker can cause the camera to work improperly.
Do not drop the camera or subject them to physical shocks.
It can cause malfunctions to occur.
Never keep the camera face to strong light directly.
It can damage CCD.
Never use the camera close to a gas or oil leak.
It can cause malfunctions to occur.
Do not disassemble the camera.
There are no user-serviceable parts inside it.
Note
If the camera is exposed to spotlight or object reflecting the strong light,
smear or blooming may occur.
Please check the power whether it satisfies the normal specification before
connecting the camera.
WARNING - Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
CAUTION - When this camera is installed near equipment, like a wireless
communication device that emits a strong electromagnetic field, some irregularity such
as noise on the monitor screen may happen.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions : (1)This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and use in accordance with the instructions, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is likely to
cause interference, in which case the user will be required to correct the interference at
his own expense.
1). Without SUN SHIELD
1). With SUN SHIELD
102
92
40
90
DC 12V
VIDEO
102
92
48
31
DC 12V
VIDEO
80 5.2
36
9
Bullet camera IR WATER PROOF
Pr
in
te
d
in
K
or
ea
User's Guide Manual color camera