Codelocks KL1000 KitLock NetCode Locker Lock - Manual (Page 2)

SPECIAL NOTES FITTING INSTRUCTIONS
The KitLock can be fitted to:
A Cabinets, cupboards and lockers
etc as a direct replacement for
existing cam locks.
B It can also be fitted easily to
cupboards and cabinets that do not
have an existing locking device.
Please see installation guide on reverse
OPEN
LOCKED
Please read carefully:
• Before installing the lock, load the
batteries and familiarise yourself with
the operation and programming.
• The handle will not turn until you
enter the factory default Master Code
11 33 55 77 or the User Code 22 44.
• Please see programming guide to set
your own codes.
• Your KitLock is supplied ready to
fit to doors up to 19mm ( 3 /
4
”) thick.
For doors between 19mm ( 3 /
4
”)
and 25mm (1”) thick, you will need
to install the 28.5mm (1 1 /
8
”) spare
spindle (see below). A 12mm ( 1 /
2
”)
spindle is also included for sheet
metal doors (see below).
KitLock
Upper fixing bolt x 2
Packer pieces x 3
Locking nut
Cams x 2
Cam fixing bolt
Batteries – 2 x 1.5V AAA
Template x 1
1
2
3
4
5
6
1. Remove the lower 2 fixing
screws.
2. Remove cover plate, spindle
and threaded shaft.
3. Replace with spare spindle
and threaded shaft.
4. Replace cover plate.