CognitiveTPG DLXi - Manual (Page 8)

CognitiveTPG Headquarters
25 Tri-State International, Suite 200, Lincolnshire, IL 60069
Toll Free: 800-732-8950 Phone: 847-383-7900 Fax: 847-383-7949
www.CognitiveTPG.com
Copyright 2011 CognitiveTPG. All Rights Reserved.
DLX-QSG0000 Rev. A 2011
Warning – Shock Hazard and Static Discharge
Never operate the printer in a location where it can get wet. Personal injury could result. The discharge of electrostatic energy that accumulates on the surface
of the human body or other surfaces can damage or destroy the printhead or electronic components used in this device. DO NOT TOUCH the printhead or the
electronic components under the printhead carriage.
Caution – Printer Setup and Handling
When installing or modifying the printer setup or configuration, ALWAYS TURN THE POWER OFF before: (1) connecting any cables, (2) performing any cleaning or
maintenance operations, or (3) moving the printer.
European Compliance
This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.
RoHS COMPLIANCE: 2002/95/EC on the Restriction of the Use of certain Hazardous Substances in Electrical and Electronic Equipment (RoHS).
WEEE:
Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). For WEEE recycling and recovery information, refer to the CognitiveTPG Web site.
Federal Communications Commission (FCC) Radio Frequency Interference Statement Warning
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Information to the User
This equipment must be installed and used in strict accordance with the manufacturer’s instructions. However, there is no guarantee that interference to
radio communications will not occur in a particular commercial installation. If this equipment does cause interference, which can be determined by turning
the equipment off and on, the user is encouraged to contact CognitiveTPG, Inc. immediately. CognitiveTPG, Inc. is not responsible for any radio or television
interference caused by unauthorized modification of this equipment or the substitution or attachment of connecting cables and equipment other than those
specified by CognitiveTPG, Inc. The correction of interferences caused by such unauthorized modification, substitution or attachment will be the responsibility
of the user. In order to ensure compliance with the Product Safety, FCC and CE marking requirements, you must use the power supply, power cord, and interface
cable which are sold for use with this product or which meet the following parameters:
This product has been tested for Safety and EMC Compliance as indicated below and is intended for use only with the Power Supply and cables included. If using
the parallel interface, please add the enclosed clamp-on ferrite to the parallel cable being used and secure it in place with the cable ties supplied.
Industry Canada (IC) Radio Frequency Interference Statement
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
DECLARATION OF CONFORMITY
Type of Equipment: Information Technology Equipment – Printer
Model: DBDXX-XXXX-XXXX
Model: DBTXX-XXXX-XXXX (X = any alphanumeric character)
Applicable EU Directives:
2004/108/EC (electromagnetic compatibility directive)
2006/95/EC (low voltage directive for product safety)
Harmonized Standards:
EN 55024 (1998/A1:2001/A2:2003) Information Technology Equipment Immunity Characteristics
EN 55022 (1998/A1:2001/A2:2003) EMC, Class A, Limits and Methods of Measurement of Interference
Characteristics of IT Equipment
IEC 60950-1 (2005) Second Edition - Product Safety Standard.
“TPG IPB, Inc., 950 Danby Road, Ithaca, New York, 14850, declares that the equipment specified
above conforms to the referenced EU Directives and Harmonized Standards.”
Date: Oct 27, 2011
Jeffrey C Phoenix, Regulatory Compliance Engineer , CognitiveTPG and TPG IPB Ref #: 189-1300070 Rev C
Copyright 2011 CognitiveTPG. CognitiveTPG and DLXi are trademarks of CognitiveTPG. Other products and corporate names
used in this publication may be trademarks or registered trademarks of other companies and are used only for explanation
and to their owner’s benefit, without intent to infringe. No part of this guide may be reproduced for any purpose or in any
form, including electronic storage and retrieval without the express permission of CognitiveTPG.