Comprehensive CVG-21RCA - Manual (Page 9)

7
5.3 Connecting the CVG-21RCA as a 2x1 Component Video Switcher
To use the CVG-21RCA as a component video (Y, B-Y, R-Y, sometimes
called YUV or Y, Pb, Pr) switcher, connect the CVG-21RCA as the example in
Figure 4 illustrates:
1. Connect a component video source (for example, a BETACAM VCR
“Component Source 1”) to the three INPUT 1 channels, as follows:
• Connect the Y component video channel to RCA connector A
• Connect the B-Y component video channel to RCA connector B
• Connect the R-Y component video channel to RCA connector C
2. Connect a second component video source (for example, a BETACAM
VCR “Component Source 2”) to the three INPUT 2 channels, as follows:
• Connect the Y component video channel to RCA connector A
• Connect the B-Y component video channel to RCA connector B
• Connect the R-Y component video channel to RCA connector C
3. Connect the three OUTPUT channels to a component video acceptor (for
example, a component video monitor), as follows:
• Connect the Y component video channel to RCA connector A
• Connect the B-Y component video channel to RCA connector B
• Connect the R-Y component video channel to RCA connector C
4. Push in the front panel INPUT SELECTOR switch to route input 2, or
release it to route input 1.
Figure 4: Connecting the CVG-21RCA as a 2x1 Component Video Switcher