Comprehensive CE-HD330RS - Manual (Page 8)

4
6.2 Receiver Front and Rear Panels
Power
Link
CAT 5e /6 In
DC 5V IR1 Extender
RS232 Out IR2 Blaster
HDMI Out
Rear Front
2 3 1 5 4 6 7 8
1 RS-232 Out: Connect to the device that is to be controlled (with
the supplied 3.5mm phone jack to D-Sub 9-pin adaptor) by RS-232
commands.
2 IR1 Extender: Connect to the supplied IR extender cable for IR
signal reception. Ensure that remote being used is within the direct
line-of-sight of the IR extender.
3 IR2 Blaster: Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line of sight of the
equipment to be controlled.
4 HDMI Out: Connect to a HDMI equipped TV/monitor for display of
the HDMI input source signal.
5 DC 5V: Plug the 5 V DC power supply into the unit and connect the
adaptor to an AC outlet.
6 Link: The yellow LED will illuminate when both the input and output
CAT5e/6 signals are connected.
7 Power: This green LED will illuminate when the device is connected
to a power supply.
8 CAT5e/6 In: Connect to the transmitter unit with a Single CAT5e/6
cable for transmission of all data signals.