Comprehensive CSW-RGBHV88A - Manual (Page 12)

RGBHV/Stereo Audio Matrix Switcher
8
5.2.1 Connection with Control Systems
With the RS-232 port, the MRG matrix switchers can be control by several kinds of control
systems.
5.2.2 Connection with Computer
When the switcher connects to the COM1 or COM2 of the computer with control software, users
can control it by that computer.
To control the switcher, users may use the RS232 software
F 5-1 Connection between MRG matrix switcher and the computer
5.3 How to Connect with the Input and Output Terminals
The MRG matrix switchers may take DVD players, computers, graphic workstations and digital showing
platform as their input signal source, and projectors, video recorders, displayers and amplifiers as their
output signal destinations according to different situation.
RGBHV connection:
The MRG matrix switchers support the Composite Video, Component Video (YPbPr), Super Video (YC)
and VGA signal source. RGBHV signal output terminals or YC output terminals are needed in AV device;
RGBHV signal output terminals are needed in VGA device.
The BNC connector is shown as the figure below.
Sleeve ( )
Tip (+)
BNC Connector
If the VGA device doesn’t with RGBHV output terminals, please convert the signals with a VGA to
RGBHV switcher for getting high quality MRG output effects.
Please use the special five core RGBHV signal cord to connect the input and output devices and
connect the BNC connector R(red) 、G（green）、B（blue）、H（horizontal）、V（vertical）carefully.
Attention:
Please make sure the RGBHV connectors from the source and to the destination should be in the same
order, otherwise it world cause color loss or no output signal at all.
Audio signal connection:
“AUDIO INPUT”, “AUDIO OUTPUTS” audio network interface in RGBHV matrix switchers can be
connected to the audio signal and amplify of the DVD player.